What are two characteristics of a Layer 2 Ethernet switch access port? (Choose two.) Access mode is the default operating mode for a port on a Layer 2 switch An access port is associated with a single VLAN An access port uses 802.1Q frame encapsulation Access ports require an SVI to be configured on the switch. A native VLAN is configured on each access port. Which packet forwarding process uses ternary content addressable memory (TCAM)? hardware CEF software CEF process switching complex packet forwarding. What is a feature of a Cisco switch SVI? An SVI is configured by setting it as a VLAN interface. An SVI is configured by virtualizing a specified physical switch interface. One SVI is associated with the switch native VLAN by default. An SVI is operational if one of the switch interfaces is associated with any VLAN. Which Cisco router component performs process switching of packets? the general-purpose CPU the ASIC the forwarding engine the TCAM. What is the difference between a routed switch port and a trunk port on a multilayer switch? A routed port is assigned an IP address. A routed switch port forwards frames in multiple VLANs. A trunk port forwards Layer 3 packets. A routed port can be connected directly to switch access ports. What would be the source of the entries in the ARP table of a particular IPv4 host? devices that the host has communicated with recently that are on the same IP network segment all devices that the host has communicated with recently only an entry for the device that is the next hop to reach a remote network devices that the host has communicated with recently that are on remote IP networks. Which is the correct description of a native VLAN on a Cisco switch? the VLAN that contains any untagged network traffic on a trunk port the VLAN that is always used to manage the switch the VLAN that is assigned to the switch SVI by default the VLAN that has a VLAN ID of 0. Which router memory component is used by CEF to make packet forwarding decisions? forwarding information base routing table label informnation base routing information base. Where does a Cisco switch store the MAC address table entries? CAM TCAM adjacency table routing table. Which CEF component enables multiple actions to be performed in addition to allowing or dropping traffic? TCAM CAM FIB RIB adjacency table. What is a feature of virtual LANs (VLANs)? Logical segmentation is provided by creating multiple broadcast domains on a single switch. A single collision domain is enabled on a switch that is shared between VLANs. Communication between different VLANs on the one switch is enabled by default. Switch port utilization is decreased because each port is only associated with one broadcast domain. What are two characteristics of Layer 2 Ethernet trunk ports? (Choose two.) Trunk ports carry multiple VLANs. Trunk ports connect a switch to other switches or to other network devices Trunk ports ensure that broadcast communications are contained within one switch. Trunk ports automatically load balance data traffic between network devices. Trunk ports are only used to connect to network end devices.
