Which command should you enter to configure an LLDP delay time of 5 seconds? lldp reinint 5 lldp reinint 5000 lldp holdtime 5 lldp timer 5000.
How can the Cisco Discovery Protocol be used? to allow a switch to discover the devices that are connected to its ports to determine the hardware platform of the device to determine the IP addresses of connected Cisco devices all of the above.
Refer to the exhibit. Which command provides this output? show ip route show ip interface show interface show cdp neighbor.
A network engineer must create a diagram of a multivendor network. Which command must be configured on the Cisco devices so that the topology of the network can be mapped? Device(Config)#lldp run Device(Config)#cdp run Device(Config-if)#cdp enable Device(Config)#flow-sampler-map topology.
An engineer needs to configure LLDP to send the port description time length value (TLV). What command sequence must be implemented? switch#lldp port-description switch(config)#lldp port-description switch(config-line)#lldp port-description switch(config-if)#lldp port-description.
In a CDP environment, what happens when the CDP interface on an adjacent device is configured without an IP address? CDP operates normally, but it cannot provide any information for that neighbor CDP operates normally, but it cannot provide IP address information for that neighbor CDP uses the IP address of another interface for that neighbor CDP becomes inoperable on that neighbor.
Which command is used to enable LLDP globally on a Cisco IOS ISR?
lldp run lldp enable lldp transmit cdp run cdp enable.
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface? lldp timer lldp holdtime lldp reinint lldp tlv-select.
|
