Which mode must be used to configure EtherChannel between two switches without using a negotiation protocol? on desireable active auto. Which two command sequences must you configure on a switch to establish a Layer 3 EtherChannel with an open-standard protocol? (Choose two) interface port-channel 10
no switchport
ip address 172.16.0.1 255.255.255.0 interface GigabitEthernet0/0/1
channel-group 10 mode auto interface GigabitEthernet0/0/1
channel-group 10 mode on interface port-channel 10
switchport
switchport mode trunk interface GigabitEthernet0/0/1
channel-group 10 mode active. interface GigabitEthernet0/0/1
channel-group 10 mode active STP does not block EtherChannel links EtherChannel provides increased bandwidth by bundling existing FastEthernet or Gigabit Ethernet interfaces into a single EtherChannel You can configure multiple EtherChannel links between two switches, using up to a limit of sixteen physical ports EtherChannel does not allow load sharing of traffic among the physical links within the EtherChannel EtherChannel allows redundancy in case one or more links in the EtherChannel fail. Refer to the exhibit.
Which two commands were used to create port channel 10? (Choose two) interface range g0/0-1
channel-group 10 mode passive interface range g0/0-1
channel-group 10 mode auto interface range g0/0-1
channel-group 10 mode active interface range g0/0-1
channel-group 10 mode desirable interface range g0/0-1
channel-group 10 mode on. Refer to the exhibit. Based on the LACP neighbor status, in which mode is the SW1 port channel configured? passive active auto mode on.