option
Cuestiones
ayuda
daypo
buscar.php

Offscale

COMENTARIOS ESTADÍSTICAS RÉCORDS
REALIZAR TEST
Título del Test:
Offscale

Descripción:
QRH handbook

Fecha de Creación: 2026/11/18

Categoría: Cine y TV

Número Preguntas: 50

Valoración:(0)
COMPARTE EL TEST
Nuevo ComentarioNuevo Comentario
Comentarios
NO HAY REGISTROS
Temario:

2. The thrust reversers are actuated by. a. Hydraulic pressure. b. DC power. c. AC power. d. pneumatics.

1. The CFM56-3 engine is a high bypass ratio turbofan with a stage N2 compressor -. 7. 8. 9. 10.

Takeoff is permitted with one PMC on and the other one inoperative. True. False.

Bleed air is taken from the and stages of the compressor. a. 6, 7. b. 5,9. c. 4, 6. d. 3, 7.

5. The start levers controls the: a. Starter and fuel. b. Fuel and ignition. c. Pneumatic pressure and fuel. d. Ignition and starter.

The ignition system is energized by activating the: a. Engine Start switch. b. Starter energizer. c. Engine Start switch and Engine Start Lever. d. Ignition Select switch.

The correct amount of fuel is metered to the engine by the: a. Fuel flow transmitter. b. Main engine control. c. Thrust lever. d. Pressurization/dump valve.

8. Minimum duct pressure required for engine start at sea Level is psi. a. 48. b. 40. C. 30. d. 25.

9. The pneumatic pressure available for engine start is indicated by the pneumatic gauge located on the panel. a. Forward overhead. b. Center instrument. c. Aft overhead.

10. If the engine START VALVE OPEN light illuminates during flight, the following step shouLd be taken first: a. Start Lever—Cutoff. b. Isolation Valve switch—CLOSE. c. Engine Bleed switch — OFF. d. Engine Start switch — OFF.

11. During engine start, position the engine start lever to the IDLE Detent when: a. N2 RPM reaches 20% and is increasing at a normal rate. b. N2 RPM reaches 25%; if it does not reach 25%, abort the start. c. N2 RPM reaches 25%, or max motoring speed with N2 above 20%.

12. For a normal engine start the Ignition Select switch should be positioned to L or R and the Engine Start switch should be positioned to. a. GRD. b. CONT. c. FLT. d. ON.

13. For takeoff, the Engine Start Switches shouLd be placed to the position. a. OFF. b. CONT. c. FLT. d. GRN.

14. The maximum N2 RPM is: a. 100%. b. 102%. c. 105%. d. 106%.

15. If the engine OIL FILTER BYPASS Light illuminates, the Thrust Lever should be retarded if flight conditions permit. a. True. b. False.

16. The Pneumatic Starter automatically cuts out when the N2 compressor reaches RPM. a. 50%. b. 42%. c. 46%. d. 35%.

17. The normal starter duty cycle is. 2 mm. on, 20 sec off (once, then 3 mm cooling). 5 mm. on, 30 sec off (twice then 5 mm cooling). 3 mnin. on, 30 sec off (twice then 3 mm cooling). Use as often as you like.

18. The maximum EGT allowed during engine start is. 725°C. 905°. 870°. 800°C.

19. The Oil Cooler uses---------------to maintain normal oil temperature. Fuel flow. Bleed air. Hydraulic fluid.

20. Illumination of the Oil Filter Bypass Light indicates: Abnormally high oil temperature. Engine failure is imminent. Impending bypass of the Main Oil Filter. Oil pressure is Less than minimum.

21 Moving the FUEL FLOW Switch to RESET (pushing the FUEL USED RESET switch, in airplanes with EIS) causes the computed fuel used to be. Shown on the digital display. Reset to zero. Shown on the analog display.

22. When the FUEL FLOW Switch is held in the USED position (FUEL FLOW/USED switch is pushed, in airplanes with EIS), the display will indicate fuel used since last. Engine start. Takeoff. Refueling. Reset.

23. ILlumination of a REVERSER UNLOCKED Light indicates. Either of the reverser sleeves is not in the stowed and locked position. The auto—restow system is inoperative. The Isolation and Selector Valves are in disagreement. The Isolation Valve is open.

24. Reverse thrust may be selected: a. Whenever the Forward Thrust Lever is at idle. b. When either radio altimeter is sensing less than 10 feet altitude. c. When the air/ground safety sensor is in the ground mode. d. Both b and c are correct.

25. The Power Management Control (PMC) wiLl adjust fuel flow in all phases off flight as a function of. a. Thrust lever angle. b. Ni RPM. c. Fan inlet temperature and pressure. d. ALL of the above.

26. When will the engines operate at High Idle RPM?. On the ground with the Flap Lever at 15 or greater. Only with either or both ENG ANTI—ICE Switches ON. In flight at all times. Only with Engine Start Switches in FLT.

1. The fuel pumps for the main and center tanks are powered by which electrical system?. a. DC. b. AC.

2. The purpose of the fuel vent system is to: a. Dump fuel inflight. b. Allow fuel to flow from the main tanks to the center tank during tanks during refueling. c. Prevent damage to the wings due to excessive buildup of positive or negative pressures inside the fuel. d. Both a and c are correct.

3. The airplane does not have a fuel dump system. True. False.

4. Each tank supplies pressurized fuel by using boost pumps. a. One. b. Two. C. Three. d. Four.

5. With the crossfeed valve closed, the left center tank boost pump will feed the left engine and the right center tank boost pump will feed the right engine, until the center tank -is dry. True. False.

6. With a complete loss of electrical power, only fuel from the ------- will be avaible. Main tanks. Center tank.

7. The fuel quantity indicators are found on the center instrument panel and require standby AC power to operate. True. False.

8. A center tank fuel pump LOW PRESSURE light will illuminate when the fuel pump switch is OFF. True. False.

9. A main tank fuel pump LOW PRESSURE light will illuminate when the pump switch is off. True. False.

10. When the crossfeed valve is open, fuel may be fed from any tank to: Any other tank. The center tank onLy. Either engine. Either engine or any other tank.

11. The engine fuel shutoff valves may be closed by: a. Pulling the Engine Fire Warning Switch. b. Placing the Engine Start Lever to CUTOFF. c. Closing the cross-feed valve. d. Either a or b.

12. Which valve interconnects the engine feed system to the fueling station?. Crossfeed valve. Fueling valve. Manual defueling valve. Dump valve.

13. When both the Crossfeed Switch and the Crossfeed Valve are open, the CROSSFEED VALVE OPEN Light will -. Illuminate bright blue. Illuminate dim blue. Illuminate red. Not illuminate.

14. Engine fuel is heated. By manually controlled bleed air. By automatically controlled electric heaters. Continuously thru an engine oil/fuel heat exchanger. All the above.

15. For a FUEL annunciator and MASTER CAUTION Light to illuminate, two fuel LOW PRESSURE Lights must be illuminated for the. Main tanks. Same tank. Center Tank. Aux Tank.

16. To close the Crossfeed Valve: Push the Crossfeed Valve Switch. Pull the Crossfeed Valve Switch to the "click stop". Rotate the Crossfeed Valve Switch 90º counterclockwise.

17. The maximum fuel imbalance for landing is ……….lbs. 800 lbs (362 kgs). 1000 lbs (453 kgs). 1100 Lbs (499 kgs). 1500 lbs(680 kgs).

18. Illumination of a fuel FILTER BYPASS Light is an indication of. Excessive fuel flow. Low fuel temperature. Impending filter bypass. Any of the above.

19. Main Tanks I and 2 must be full if the Center Tank contains more than…. 2000 lbs (908 kgs). 1000 Lbs (453 kgs). 500 lbs (227 kgs). 1675 lbs (760 kgs).

20. The Engine Fuel Shutoff valve is: AC powered and controlled by the Engine Start Lever and/or the Engine Fire Switch. DC Powered and controlled by the Engine Start Lever and/or the Engine Fire Switch. AC powered and can be controlLed onLy by the Engine Start Lever. DC powered and can be controlled only by the Engine Start Lever.

21. What ensures proper fuel flow direction and prevents transfer of fuel between tanks?. Fuel boost pumps that operate with different pressures. Dedicated fuel lines from each tank to both engines. The crossfeed valve. Check valves.

The purpose of the single-point fueling system is to allow: Rapid fueling. Ground fuel transfer. Defueling. All of the above.

23. It is not possible to service the center tank without single-point fueling. True. False.

24. Which of the following statements concerning the fuel boost pumps is true?. a. If generator No. I fails, both boost pumps in main tank No. I are inoperative. b. If the FWD boost pump in main tank No. 2 fails, the LOW PRESSURE Light, the Fuel Annunciator Light and the MASTER CAUTION Light will illuminate. c. If all fuel boost pumps fail above 30,000 feet, engine flameout will occur. d. With the loss of all generators, both center tank boost pumps are inoperative and the fuel in the center tank is no longer usable.

Denunciar Test