One of the most frequent configurations on a router involves setting up of a static route. Consider the following command given on a router running Cisco IOS:
“ip route 165.44.34.0 255.255.255.0 165.44.56.5”.
Which one of the following is true?
A) 165.44.56.5 is the destination IP address B) 165.44.56.5 is the default gateway address. A branch office is connected to the ISP as shown in the figure. Which router is most likely to be configured with a static route? A) ISP Router B) R1. You are a network admin at ABC Corp., and you recently added a Cisco IOS router to your local office. You need to configure a static route on the router (say, RouterA) to network 192.204.1.64. What is the command that you need to give? Assume that the router is running Cisco IOS. A) RouterA(config)#ip route 192.204.1.64 255.255.255.240 192.204.1.2 B) RouterB(config)#ip route 192.204.1.64 255.255.255.240 192.204.1.2. A branch office is connected to the Internet using a network device as shown in the figure. Which network device fulfills the requirement? A) Router with one Ethernet and one Serial interfaces B) Router with two Ethernet interfaces. You have configured RIP on your IOS router connected to your Corporate IP network. Now you want to remove RIP entries. What is the command used for this? A)stop router rip B) no router rip . RIP uses ____________ algorithm A) Distance state B) Distance vector. Please refer to the figure below. HostA needs to access SwichA management interface (VLAN1). A) Configure default gateway on SwitchA B) Change SwitchA VLAN1 ip address. The network shown below is experiencing connectivity problems. Which of the given below options will correct the problems? A) Configure the gateway on Host B as 192.168.2.1 and Configure the IP address of Host B as 192.168.2.129 B) Configure the gateway on Host A as 192.168.2.1 and Configure the IP address of Host A as 192.168.2.129. Refer to the figure below, hosts on the same VLAN can communicate with each other but are unable to communicate with hosts on different VLANs. What is needed to allow communication between VLANs A) a router with an IP address on the physical interface that is connected
to the switch
B) a router with sub-interfaces configured on the physical interface that is
connected to the switch
. Please refer to the figure below. HostA was not able to ping HostB. A trace route command issued a HostA has the following output displayed: A) The gateway address on Host A is not configured properly B)The gateway address on Host B is not configured properly. A branch office is connected to the ISP as shown in the figure. Which router is most appropriate for configuring default route? A) R1 B)R2. The routers A and B are configured as shown in the figure. Host A and Host B are configured properly. A ping from host A is able to get a successful response from S0 of RouterB, but failed to get any response from Host B. What is the likely problem? A) The subnet mask on network 192.204.1.64 /28 is not correct. B) Router A doesn’t have route to network 192.204.1.64/28. Which of the following addresses represent the 128-bit loopback address in IPv6? (Choose two) A)::1 and 0:0:0:0:0:0:0:1 B):1 and 0:0:0:1. The feature of IPv6 which allows a client to receive an IP address without the use of DHCP server is which of the following? A) Stateless autoconfiguration B)Stateless DHCP. Which of the following is NOT a wireless security standard? A)WPA B) SSID. Your network has 120 computers running Windows Operating System. You have decided to connect your network to the Internet using a T1 line. You want every workstation to be able to browse the web.
However, you are given only one IP address to access the Internet. What device can be used to allow all work stations access the Internet?
A) Proxy Server B)Bridge. Which one of the following is the shortest valid abbreviation for the Ipv6 address A) 3001:0:0:100::345 B)3001::100::345.
|