option
Cuestiones
ayuda
daypo
buscar.php

Test 3. 767 200,300

COMENTARIOS ESTADÍSTICAS RÉCORDS
REALIZAR TEST
Título del Test:
Test 3. 767 200,300

Descripción:
Guia de estudio para el test

Fecha de Creación: 2026/04/22

Categoría: Otros

Número Preguntas: 21

Valoración:(0)
COMPARTE EL TEST
Nuevo ComentarioNuevo Comentario
Comentarios
NO HAY REGISTROS
Temario:

On which fuel tank does the NGS decrease  the oxygen in the air prevent fixes and explosions: In the main fuel tanks. In all the fuel tanks. In the center fuel tank.

How is the APU started?. Through the generator using 115VAC. Using a 115VAC powered electric motor. Using a 28VDC powered electric motor.

Where can the flight deck zone trim air modulating valve position be observerd?. On P5 AC PANEL only. On EICAS ECS/MSG page only. On P5 A/C PANEL and on EICAS ECS/MSG.

Are both primary and secondary heat exhangers the same?. Yes, they are exactly the same and interchangeable. No, the primary has a wider ram air flow section and wider ram air outlet. No, the secondary has a wider ram air flow section and stronger fins.

In case of a failure on one cabin pressure controller, willit automaticaly Swap ta operative controller?. Yes but manual selection must be cycled. Yes it will change automatically. Noit must be manually selected on P5.

Which component provides the zone temperature value to its related zone temperatun controller (ZTC)?. Temperature bullb. Temperature switch. Temperature sensor.

On which cooling pack mode wil the pack be set to supply the most amount of cooling?. STBY N mode. Any STBY mode. STBY C mode.

Which of the below conditions can cause the pack "INOP" light to illuminate on the P5 panel?. Pack outlet overheat (190F). Flow control valve is closed. Pack control switch is selected to off.

Which air conditioning source supplies the flight compartment air distribution? QUESTIONS SHEET. Left Pack. Mix manifola. Right Pack.

When is the inboard supply valve of the FWD equipment cooling open?. On ground, switch in AUTO and both engines running. On ground, switch in AUTO and engines not running. In flight, switch in AUTO and no fire detected on FWD cargo.

During normal operation on AFT equipment cooling system which fan operates when switch on P5 is in AUTO?. FAN 1. A/ternate on flight basis. FAN 2.

On the air cycle machine which component is responsible for the shaft rotation?. Turbine. Ram Fan. Compressor.

When in flight and the equipment cooling mode selector is in "STBY", which fan operates?. Exhaust fan. Supply fan. None.

Which electrical bus powers the lavatory smoke detectors?. Left DC BUS. Right DC BUS. Hot Battery Bus.

(PW 4000) Which mode value does the EEC use normally to control the engine?. N2 mode. N1 mode. EPR mode.

(PW 4000) Which are the different Engine Start System air sources?. A dedicated start air compressor and APU air. Ground air, APU air and engine air. From either, left or right engine air.

(PW 4000) Which component controls the fuel flow through the FMU and protects the engine?. The Fuel Metering Unit (FMU). The Electronic Engine Controls (EEC). The Flight Management Computer (FMC).

Through the standpipe what is the useable capacity of the main water tank?. 170 liters. 370 liters. 413 liters.

In order to perfomr a auto zero adjustment on the LCM what must accomplished?. Disconnect the continuous level sensor from LCM. Disconnect point level sensors and waste tank empty. The waste tank must be full and point level sensor fooled.

When does the Cargo Compartment Fire Alarm sound: When an overheat is detected on any of the Cargo Compartments. When smoke is detected on any of the Cargo Compartments. If any of the Cargo Compartment fire extinguisher bottles has discharged.

How are the engine fire extinguisher bottles discharged?. Automatically, when fire is detected. Automatically, when smoke is detected. Manually, by two engine fire handles.

Denunciar Test