Drawings Bo

Which of the following is a basic effectivity. 763. P3990.

Drawing shows what to do and the engineering standards tell how it must be done", regarding the above statement. False. True.

Wnich drawing gives all the information for fabricating single parts?. Detail Drawings. Asssembly drawing.

A part number consist of the following: a) Drawing number + Dash number. b) Dash number.

- A drawing in which the subassemblies or parts are shown as brought together on the aircraft located on the aircraft , is called. a) Detail drawing. b) Assembly drawing.

Talking about part numbers for opposite part, which dash number will be asigned to the left side parts. Odd number. Even number.

Which of the following information is showed by the part list?. a) Where, and how many times part is used. What the size and the shape the parts are.

8- Zone numbers on aircraft blueprints are used to. a) to locate parts , sections, and views on large drawings. b) indicate different sections of the aircraft.

Which statement is true regarding an orthographic projection?. c) In practice, only two or three views are needed to fully describe a part. a) It could have as many as eight views.

10.- Identify the left side view of the object shown. A) 1. c) 3.

11.- What type of line is normally used in a blueprint to represent an edge or object not visible to the viewer?. b) Medium Solid Line. c) Alternate Short and long light dashes.

Which IS the Length of the following fastener. 3/8. 3/32.

"Permanent fastener are shown using fastener symbol codes regarding the above statement. Is true. Is falso.

In the reading of aircraft blueprints the ferm tolerance, used in association with aircraft parts or components. a) is the difference between maximun and minimun dimension limits. b) are numercal alues.

If a part is detailed on an assembly drawing, all the information needed to make the part will be given regardinq the above statement. Is true. Is falso.

When reading a blueprint, a dimension is given as 4.388 inches +.003 -.003. Which statement is true?. a) the maximun aceptable size is 4.391 inches. b) The minimum aceptable sIze is 4.383 inches.

The measurements showing the ideal or 'perfect' sizes of parts on drawings are called. a) allowance. B) dimensions.

The Revision block on the picture sheet is always located in the. a) upper right corner. b) lower left corner.

What type of line is normally used in a rawing to represent the edges of a object ?. a) Medium Solid line. c) Alterate Short and long light dashes.

The tile block on the picture sheet is always located in the. a) upper right corner. b) lower right corner.