HPE6-A85.Cap1

A network technician is using Aruba Central to troubleshoot network issues Which dashboard can be used to view and acknowledge issues when beginning the troubleshooting process?. A. the Alerts and Events dashboard. B. the Audit Trail dashboard. C. the Reports dashboard. D. the Tools dashboard.

Based on the given topology, what is the requirement on an Aruba switch to enable LLDP messages to be received by Switch 1 port 1. when Router 1 is enabled with LLDP?. A. LLDP is enabled by default. B. global configuration lldp enable. C. int 1, lldp receive. D. int 1, no cdp.

You are in a meeting with a customer where you are asked to explain the network redundancy feature Multiple Spanning Tree (MSTP). What is the correct statement for this feature?. A. MSTP configuration ID revision by default as current MSTP root priority. B. MSTP configuration ID name by default using switch IMC address. C. MSTP configuration ID name by default using switch serial number. D. MSTP configuration ID revision by default as switch serial number.

When using the OSPF dynamic routing protocol on an Aruba CX switch, what must match on the neighboring devices to exchange routes?. A. Hello timers. B. DR configuration. C. ECMP method. D. BDR configuration.

DRAG DROP Match the phase of message processing with the Open Systems interconnection (OSl) layer. 1) Physical layer. 2) Data Link layer. 3) Network layer. 4) Transport layer.

DRAG DROP Match the feature to the Aruba OS version (Matches may be used more than once.). a) Aruba OS 8. b) Aruba OS 10.

Which Aruba technology will allow for device-specific passphrases to securely add headless devices to the WLAN?. A. Wired Equivalent Privacy (WEP). B. Multiple Pre-Shared Key (MPSK). C. Opportunistic Wireless Encryption (OWE). D. Temporal Key Integrity Protocol (TKIP).

Refer to the exhibit. In the given topology, a pair of Aruba CX 8325 switches are in a VSX stack using the active gateway What is the nature and behavior of the Virtual IP for the VSX pair if clients are connected to the access switch using VSX as the default gateway?. A. Virtual IP is active on the primary VSX switch. B. Virtual floating IP will failover in case of a failure. C. Virtual IP is active on both CX switches. D. Virtual IP uses SVI IP address synced with VSX.

When performing live firmware upgrades on Aruba APs. which technology partitions all the APs based on RF neighborhood data minimizing the impact on clients?. A. Aruba ClientMatch. B. Aruba Ai insights. C. Aruba AirMatch. D. Aruba ESP.

What happens when the signal from an AP weakens by being absorbed as it moves through an object?. A. APs will use bonded channels to decrease latency to clients. B. Signal to Noise Ratio (SNR) increases. C. Signal to Noise Ratio (SNR) decreases. D. Aruba Central dynamically moves clients to neighboring APs.

Based on the "snow ip route" output on an AruDaCX 8400. what type of route is "10.1 20 0, vrf default via 10.1.12.2. [1/0]"?. A. local. B. static. C. OSPF. D. connected.

Which device configuration group types can a user define in Aruba Central during group creation? (Select two.). A. Security group. B. Template group. C. Default group. D. Ul group. E. ESP group.

What is the correct command to add a static route to a class-c-network 10.2.10.0 via a gateway of 172.16.1.1?. A. ip-route 10.2.10.0 172.16.1.1. B. ip route 10.2.10.0.255.255.255.0 172.16.1.1 description aruba. C. ip route 10.2.10.0.172.16.11. D. ip route-static 10.2 10.0.255.255.255.0 172.16.1.1.

You need to configure wireless access for several classes of loT devices, some of which operate only with 802 11b. Each class must have a unique PSK and will require a different security policy applied as a role There will be 15-20 different classes of devices and performance should be optimized Which option fulfills these requirements''. A. Single SSID with MPSK for each loT class using 5 GHz and 6 GHz bands. B. Single SSID with MPSK for each loT class using 2.4GHz and 5 GHz bands. C. Individual SSIDs with unique PSK for each loT class, using 5GHz and 6 GHz bands. D. Individual SSIDs with unique PSK for each loT class, using 2.4GHZ and 5GHz band.

The noise floor measures 000000001 milliwatts, and the receiver's signal strength is -65dBm. What is the Signal to Noise Ratio?. A. 35 dBm. B. 15 dBm. C. 45 dBm. D. 25 dBm.

DRAG DROP Match the switching technology with the appropriate use case. a) Controls the dynamic addition and removal of ports to groups. b) Tags Ethernet frames with an additional VLAN header Technology. c) Used to authenticate EAP-Capable client on a switch port. d) Used to identify a voice VLAN to an IP phone.

Which commands are used to set a default route to 10.4.5.1 on an Aruba CX switch when ln-band management using an SVl is being used?. A. iP default-gateway 10.4.5.1. B. ip route 0 0 0.070 10.4 5.1 vrf mgmt. C. ip route 0.0 0 0/0 10.4.5.1. D. default-gateway 10.4.5.1.

Two independent ArubaOS-CX 6300 switches with Spanning Tree (STP) settings are interconnected with two cables between ports 1 and 1 All four ports have "no shutdown" and "no routing" commands. How will STP forward or discard traffic on these ports?. A. The switch with the lower MAC address will forward on both ports, while the switch with the higher MAC address will forward on both ports. B. The switch with the lower MAC address will forward on both ports, while the switch with the higher MAC address will discard on one port. C. The switch with the lower MAC address will discard on one port, while the switch with the higher MAC address will forward on both ports. D. The switch with the lower MAC address will discard on one port, while the switch with the higher MAC address will discard on one port.

What are the main characteristics of the 6 GHz band?. A. Less RF signal is absorb by objects in a 6 GHz WLAN. B. In North America, the 6 GHz band offers more 80 MHz channels than there are 40 MHz channels in the 5 GHz band. C. The 6 GHz band is fully backward compatible with the existing bands. D. Low Power Devices are allowed for indoor and outdoor usage.

A hospital uses a lot of mobile equipment for the diagnosis and documentation of patient data What Is the ideal access switch for this large hospital with distribution racks of over 400 ports in a single VSF stack?. A. CX 6300. B. OCX 6400. C. OCX 6200. D. OCX 6100.

A network technician has successfully connected to the employee SSID via 802 1X Which RADIUS message should you look for to ensure a successful connection?. A. Authorized. B. Access-Accept. C. Success. D. Authenticated.

You need to drop excessive broadcast traffic on ingress to an ArubaOS-CX switch What is the best technology to use for this task?. A. Rate limiting. B. DWRR queuing. C. QoS shaping. D. Strict queuing.

What does WPA3-Personal use as the source to generate a different Pairwise Master Key (PMK) each time a station connects to the wireless network?. A. Session-specific information (MACs and nonces). B. Opportunistic Wireless Encryption (OWE). C. Simultaneous Authentication of Equals (SAE). D. Key Encryption Key (KEK).

You need to troubleshoot an Aruba CX 6200 4-node VSF stack switch that fails to boot correctly Select the option that allows you to access the switch and see the boot options available for OS images and ServiceOS. A. Member 2 RJ-45 console port. B. Member 2 switch mgmt port. C. Conductor USB-C console port. D. Conductor mgmt port using SSH.

Which part of the WPA Key Hierarchy is used to encrypt and/or decrypt data''. A. Pairwise Temporal Key (PTK). B. Pairwise Master Key (PMK). C. Key Confirmation Key (KCK). D. number used once (nonce).