HPE6-A85.Cap6

What is the ideal mounting position for a typical Aruba indoor AP?. Vertical, at a wall. Under a office desk. Horizontal, above a suspended ceiling. Horizontal, below a suspended ceiling.

The noise floor measures .000000001 milliwatts, and the receiver's signal strength is -65dBm. What is the Signal to Noise Ratio?. 35 dBm. 15 dBm. 45 dBm. 25 dBm.

What is indicated by a solid amber radio status LED on an Aruba AP?. Not enough PoE is provided from the switch to power both radios of the AP. Tha radio is working in mesh mode. The radio is enabled in monitor or spectrum analyses mode. The radio is working in the 5 GHz band only.

What does WPA3-Personal use as the source to generate a different Pairwise Master Key (PMK) each time a station connects to the wireless network?. Session-specific information (MACs and nonces). Simultaneous Authentication of Equals (SAE). Opportunistic Wireless Encryption (OWE). Key Encryption Key (KEK).

Which Protocol Data Unit (PDU) represents the data link layer PDU?. PDU1 - Signal. PDU4 - Segment. PDU3 - Packet. PDU2 - Frame.

What information is required when using the ClearPass self-service registration page to generate a Multiple Pre-Shared Key (MPSK) for headless devices?. The device's OS type. The device's IP address. The device's model number. The device's MAC address.

Which field in a Layer 3 IPv4 packet header is used to mitigate Layer 3 route loops?. Checksum. Destination IP. Time To Live. Protocol.

Which statement about manual switch provisioning with Aruba Central is correct?. Manual provisioning does not require DHCP and requires DNS. Manual provisioning requires DHCP and requires DNS. Manual provisioning requires DHCP and does not require DNS. Manual provisioning does not require DHCP and does not require DNS.

When using the network check page in Central, what kind of tests can you run on switches? (Select two.). PoE-check. Ping test. A full hardware check, including a heavy memory check. Speed test (iperf). LED-check.

Which commands are used to set a default route to 10.4.5.1 on a an Aruba CX switch when in-band management using an SVI is being used?. ip route 0.0.0.0/0 10.4.5.1. default-gateway 10.4.5.1. ip route 0.0.0.0/0 10.4.5.1 vrf mgmt. ip default-gateway 10.4.5.1.

What are two characteristics of ClientMatch? (Select two.). It helps to move sticky clients to another AP. It is used to locate client. It optimizes channels of an AP. An algorithm to adjust RF patterns. It is an Aruba patented technology.

Which statement is correct when comparing 5 GHz and 6 GHz channels with identical channel widths?. 5 GHz channels travel different distances and provide different throughputs to clients compared to 6 GHz channels. 5 GHz channels travel the same distances and provide the same throughputs to clients compared to 6 GHz channels. 5 GHz channels travel the same distances and provide different throughputs to clients compared to 6 GHz channels. 5 GHz channels travel different distances and provide the same throughputs to clients compared to 6 GHz channels.

You need to drop excessive braodcast traffic on ingress to an ArubaOS-CX switch. What is the best technology to use for this task?. Strict queuing. Rate limiting. DWRR queuing. QoS shaping.

The customer has a requirement to create authorization policies for their users with Windows 10 clients, with a requirement for authorizing both device and user credentials within one Radius session. What would be the correct solution for the requirement?. ClearPass 6.9 with EAP-TTLS. ClearPass 6.9 with PEAP. ClearPass 6.9 with EAP-TEAP. ClearPass 6.9 with EAP-TLS.

What is indicated by a flashing amber global status indicator LED on an Aruba CX6200M?. Self-test is in progress. The switch has a recoverable fault. The firmware image is corrupt. The switch is booting the firmware image.

A client connects to an Aruba AP in tunnel mode and is assigned to a VLAN based on the client's MAC address. Which client VLAN assignment was configured?. Mixed. Native VLAN. Dynamic. Static.

Select the correct matches for phases of message processing with the Open Systems Interconnection (OSI) layer. Physical Layer - Organizes the data into segments Data Link Layer - Organizes the data into packets Network Layer - Organizes the data into frames Transport Layer - Organizes the data into bits. Transport Layer - Organizes the data into segments Network Layer - Organizes the data into packets Data Link Layer - Organizes the data into frames Physical Layer - Organizes the data into bits. Network Layer - Organizes the data into segments Transport Layer - Organizes the data into packets Data Link Layer - Organizes the data into frames Physical Layer - Organizes the data into bits. Transport Layer - Organizes the data into segments Network Layer - Organizes the data into packets Physical Layer - Organizes the data into frames Data Link Layer - Organizes the data into bits.

What is used by network devices to send error and operational information related to IP communications?. User Datagram Protocol (UDP). Cyclic Redundancy Check (CRC). Frame Check Sequence (FCS). Internet Control Message Protocol (ICMP).

When performing live firmware upgrades on Aruba APs, which technology partitions all the APs based on RF neighborhood data, minimizing the impact on clients?. Aruba ESP. Aruba ClientMatch. Aruba AirMatch. Aruba AI Insights.

Describe the functionality of ARP. ARP uses multicast to build the ARP table. ARP maps layer-3 IP addresses to layer-2 MAC addresses. ARP maps MAC addresses to switch ports. Clients do not have an ARP cache and always ask for the default gateway.

Describe the purpose of the administrative distance. The higher administrative distance is preferred. The administrative distance for a static route is 10. Routes learned via external BGP have a higher administrative distance than routes learned via OSPF. The administrative distance is used as a trust rating for route entries.

What describes Clearpass OnGuard? (Select two.). OnGuard is an agent, running on client systems. It is used for the self-registration of guest devices. It is intuitive portal for users to securely configure their devices. OnGuard is doing posture checks on client systems. OnGuard assigns an unique identify to each device.

What is the ideal Aruba access switch for a cost-effective connection to 200-380 clients, printers, and APs per distribution rack?. Aruba CX 6400. Aruba CX 6000. Aruba CX 6300. Aruba CX 6200.

A customer has just implemented user and device certificates via a company-wide Group Based Policy (GPO). Which EAP method requires client certificates when authenticating to the network?. EAP-TEAP. EAP-TLS. EAP-TTLS. PEAP.

A hospital uses a lot of mobile equipment for the diagnosis and documentation of patient data. What is the ideal access switch for this large hospital with distribution racks of over 400 ports in a single VSF stack?. CX 6200. CX 6100. CX 6300. CX 6400.

You have physical access to an Aruba CX-Switch with unknown/lost credentials. What are the possible steps to rebuild the credentials? (Select two.). Call Aruba support for a one-time password. Use boot profile 0. Connect the switch via the console. Then, power cycle the switch. Press and hold the clear button. Then, power-cycle the switch. Press and hold the clear button. Then, press the reset button for 2 seconds and release both buttons.

You need to configure wireless access for several classes of IoT devices, some of which operate only with 802.11b. Each class must have a unique PSK and will require a different security policy applied as a role. There will be 15-20 different classes of devices and performance should be optimized. Which option fulfills these requirements?. Individual SSIDs with unique PSK for each IoT class, using 5 GHz and 6 GHz bands. Single SSID with MPSK for each IoT class, using 2.4 GHz and 5 GHz bands. Individual SSIDs with unique PSK for each IoT class, using 2.4 GHz and 5 GHz band. Single SSID with MPSK for each IoT class, using 5 GHz and 6 GHz bands.

Two independent ArubaOS-CX 6300 switches with Spanning Tree (STP) settings are interconnected with two cables between ports 1/1/1 and 1/1/2. All four ports have "no shutdown" and "no routing" commands. How will STP forward or discard traffic on these ports?. The switch with the lower MAC address will forward on both ports, while the switch with the higher MAC address will discard on one port. The switch with the lower MAC address will discard on one port, while the switch with the higher MAC address will discard on one port. The switch with the lower MAC address will forward on both ports, while the switch with the higher MAC address will forward on both ports. The switch with the lower MAC address will discard on one port, while the switch with the higher MAC address will forward on both ports.

Which Aruba technology will allow for device-specific passphrases to securely add headless devices to the WLAN?. Opportunistic Wireless Encryption (OWE). Wired Equivalent Privacy (WEP). Temporal Key Integrity Protocol (TKIP). Multiple Pre-Shared Key (MPSK).

Where are wireless client roaming decisions made?. Client device. Aruba Central. Joint decision made by the origination and destination APs. Virtual Controller.