YOU CAN DO IT

Question 3: ATA 26 Fire Protection Where are the fire detectors?. Exhaust and Pylon, Zone 2 and 3. Zone one left and right, Zone 2 and 3. Pylon, Zone 1 left and right, Zone 2 and 3.

17. ATA 79 Engine Oil Where is the Engine oil temperature sensor located?. upstream of the SAOHE (Surface Air Oil Heat Exchanger). in the combined oil scavenge pipe. downstream of the FOHE (Fuel Oil Heat Exchanger).

21. ATA 70 Construction, Arrangement and Operation /How is the Slat to T/R Cowl clearance maintained? by a cut out in the Slat. by a cut out in the Slat. by a Cowl Open Proximity Switch inhibiting the Slat Operation. by a Slat Clearance Panel on the Inboard Translating Sleeves.

1. ATA 77 Engine Indicating /How does the EIVMU communicate with the EEC?. The EIVMU communicates data to/from the EEC by an ARINC connection. There is no direct data connection between the EIVMU and the EEC. The EIVMU communicates data to/from the EEC by an Ethernet link.

14. ATA 30 Ice and Rain Protection /What valve gives primary regulation for the engine anti-ice system?. PRSOV (Pressure Regulating and Shutoff Valve). PRV (Pressure Regulating Valve). Both at the same time.

30. ATA 36 Pneumatic/When energized, what pressure does the PRV (Pressure Regulation Valve) regulate downstream pressure to?. 60 PSI. 40 PSI. 50 PSI.

18. ATA 79 Engine Oil/How can you see the engine oil level?. By a sight-glass on the oil tank. By a dial gauge on the oil tank. By the dip-stick on the oil tank.

12. ATA 73 Engine Fuel and Control How does the EEC control the HMU rate of fuel flow?. by using a Electro Hydraulic Servo Valve. by using a dual LVDT. by using solenoid valves.

11. ATA 73 Engine Fuel and Control Which components use servo fuel to operate?. Thrust reverser primary/secondary locks. IP and HP bleed valves. VIGV/VSV.

9. ATA 76 Engine Controls What is the total number of N1 sensors on the engine?. 8. 4. 6.

5. ATA 78 Exhaust Which T/R actuators provide a Primary Lock?. middle actuators. lower actuators. upper and lower actuators.

2. ATA 77 Engine Indicating What engine data shows on the CRUISE page?. Fuel used, fuel flow and engine vibration indication. Fuel used indication only. Fuel used, oil quantity and engine vibration indication.

25. ATA 70 Standard Practices Engine Which direction do the engine shafts turn (AFT looking FWD). N1 Low pressure and N2 intermediate pressure shaft counter-clockwise, N3 high pressure shaft clockwise. N1, N2, N3 all turning counter-clockwise. N1 Low pressure and N3 high pressure shaft clockwise, N2 intermediate pressure shaft counter-clockwise.

13. ATA 72 Engine Performance How is are the EEC Engine Temperature values are trimmed from. DEP (Data entry plug) data. EIU (Engine Interface Unit) data. EEC (Engine Electronic Controller) data.

ATA 74 Ignition Which ECAM message is not related to ignition system monitoring?. ENG X IGN BOTH FAULT. ENG X IGN A+B FAULT. ENG X IGN A (B) FAULT.

19. ATA 75 Air What air goes through the HPTCC valve?. LPC discharge air. 4th stage HPC air. Fan air.

23. ATA 70 Standard Practices Engine What is the purpose of the engine nacelle?. Aerodynamic structure around the engine. Reduce noise of cold and hot air stream. Attaches the engine to the strut.

6. ATA 78 Exhaust What ECAM message shows when the thrust reverser is deployed?. REV green in the middle of N1 dial. REV green in the middle of N1 dial and green MEMO on ECAM WD. REV white in the middle of N1 dial.

31. ATA 72 Engine (Turbine / Turboprop) What is the arrangement of the turbine section?. 1 high pressure turbine stages and 5 low pressure turbine stages. 2 stage high pressure turbines, 3 stage intermediate pressure turbine and 4 stage low pressure turbine. 1 stage high pressure turbines, 1 stage intermediate pressure turbine and 6 stage low pressure turbine.

10. ATA 73 Engine Fuel and Control When does the PMA supply power to the EEC?. N1 < 6%. > 6% N3. When OMS is in the interactive mode.