ATA 34

(ATA 44) What powers the eX2 in-flight entertainment system's Seat Power Module (SPM)?. A. IFE built in power source. B. Aircraft battery bus. C. Aircraft 115VAC 3 phase.

(ATA 35) Where the crew oxygen cylinder pressure is displayed?. A. On EICAS Status page and direct reading gauge on oxygen bottle regulator. B. On EICAS Maintenance page and direct reading gauge on oxygen bottle regulator. C. On overhead panel gauge and direct reading gauge on oxygen bottle regulator.

(ATA 34) How can the each Air Data Computer be tested?. A. Through the MCDP (Maintenance Control Display Panel). B. Via the test switches on the P61 maintenance panel. C. Through the FMC CDU Maintenance Page.

(ATA 34) When is the IRS (Inertial Reference System) test inhibited in the NAV mode?. A. When main landing gear shock struts are de-compressed. B. When main landing gears are in up and locked position. C. When ground speed exceeds 20 kts.

(ATA 34) Which control panel allows you to tune the DME frequency?. A. ADF control panel. B. VOR control panel. C. Navigation control panel.

(ATA 34) How can the crew select NAV mode after active ATT mode?. A. At first select ALIGN, than NAV. B. At first select OFF, than NAV. C. Just place selector switch to NAV.

(ATA 34) What data is send to Inertial Reference unit for wind computation?. A. True air speed from Air Data Computer. B. Linear accelerations from Flight Data Acquisition Unit. C. Total pressure from Pitot probes.

(ATA 34) Which position of the DSPL SEL switch can also be used to display maintenance codes?. A. TK/GS. B. HDG. C. WIND.

(ATA 34) What FMC CDU page can be used to check VOR tune?. A. INIT/REF page. B. CRZ page. C. PROG page.

(ATA 34) When is the ILS deviation warning enabled?. A. When the radio altitude signal is enabled. B. When the autopilot approach mode is selected. C. When the back course mode is activate.

(ATA 34) What data is independently calculated by FMC?. A. Ground speed, track, wind vector. B. Velocity, heading, absolute height. C. Computed air speed, total air temperature.

(ATA 34) What does the message WXR DSPY indicate?. A. The EHSI reaches an overheat condition. B. The symbol generator senses range disagreement. C. The calibration fault occurs.

(ATA 34) How is the Altitude Reference Index on the Altimeter controlled?. A. By using own Altitude Reference Set Knob located on the front face of altimeter. B. By using baro-correction switch on the EFIS (Electronic Flight Instrument System). C. By altitude selection on the autopilot MCP (Mode Control Panel).

(ATA 34) What indicator use internal vibrator to reduce friction errors and to improve indicator response?. A. Electric Altimeter. B. Pneumatic altimeter. C. Each Mach Airspeed Indicator.

(ATA 34) What is the data source for Vertical Speed Indicator?. A. Digital data signals from Inertial Reference System. B. Analog signals from Air Data Computer. C. Air pressure from Pitot and static ports.

(ATA 34) From what system does the standby attitude/ILS indicator take glide slope and localizer deviation data?. A. Center ILS receiver. B. Right FMC. C. Left FCC.